This UV protected car magnet comes in 2 sizes
Big - 6.5 x 5.75 inches
Small - 4.5 x 4 inches
Application Instructions*
- Preparation
- Before affixing the Magnet to a metal surface, be sure all surface paints, clear coats and waxes are cured or hardened. Approximate curing times are: paint - 90 days, clear coat - 60 days, wax - 2 days.
- Prior to application, clean the metallic surface and the Magnet with a mild detergent. Wipe with a soft cloth and allow to dry. Follow the recommendations on the detergent and those of the car manufacturer.
- The Magnet should be at room temperature when applying.
- Take care when handling the Magnet in extremely cold conditions, as it can become brittle.
-
- Determine the location to place the Magnet
- Ensure surface is metallic and smooth, flat or only slightly curved.
- Don’t apply the Magnet on an area that isn’t steel or metal or that has extensive non-metallic fillers. Aluminium, wood or fiberglass will not function as a surface.
- Affix the Magnet onto the surface.
- Make sure the entire Magnet is flat against the metal surface. Do not place over protrusions (moulding, decals, pin striping, etc.) or concave areas.
- Ensure there are no air pockets or moisture between the Magnet and the vehicle surface and that corners and edges are smooth and flush with the surface.
- Curvature on the edges of the Product may result in the Magnet falling off.
- To adjust the location of the Magnet after placement, remove completely and reposition by lifting from the sides to remove; do not remove from the corners. Please note that sliding the Product into position may cause stret